Docks

Wave Breakers for exposed locations

Wave Breaker has great stability and buoyancy. Its high weight makes it suitable for exposed locations. Increased width will amplify wave reducing effect further.
The design consists of reinforced concrete with a core of foam, making it unsinkable and gives it a long life. Wave breakers are equipped with extended long sides, so-called wings.

  • Standard widths are 3.0 and 4.0 meters.
  • The standard length is 12.5 and 15.0 meters.
  • The height is 1.85 meters.
  • Freeboard height is about 0.5 meters.
  • The anchoring is done with chains or Seaflex.

TECHNICAL DATA (pdf) »


Concrete Pontoon - For less exposed locations

Concrete pontoon has great stability and buoyancy, making it suitable for less vulnerable locations, wave height should not exceed 1 meter. Pontoon can be used as a wave breaker, depending on their design and weight, increased width will amplify wave reducing effect further. The advantage of the pontoons is that you can continually modify and rebuild when needs change.

The design consists of reinforced concrete with a core of foam, making it unsinkable and gives it a long life.

  • Standard widths are 2.4, 3.0 and 4.0 meters.
  • Standard lengths are 10.0, 12.5, and 15.0 meters.
  • The height is 0.95 meters.
  • Freeboard height is about 0.5 meters.
  • The anchoring is done by chain, rope or Seaflex.

TECHNICAL DATA (pdf) »


Wood & Concrete Dock for calm waters

technical description
Dock CW-250

standard width
length
weight
load
freeboard
concrete
reinforcement
Frame 
Fender   
Deck 
Pontoon 
Pontoon C-C  

2.10 m or 2.50 m (can also be delivered in different width, for example. 2.40m)
9.0 m to the desired length
365kg/m2
175kg/m2
0,45m - 0,55m
C35/45 0.40 / 4.0% air, Freeze tested
NPS 50
75x150 unplaned pressure impregnated pine
45x195 Planed pressure impregnated Pine (also on the dock ends)
34x145 groove pressure impregnated pine
2000x2400x670mm
5.40m

The dock is normally anchored with 19mm galvanized chain approximately every ten meter with 2 concrete anchors, 1200-1.450kg each.
The frame construction consists of strong coarse beams 75x150mm.
On the outsides around (although the bridge ends) is a planed edge board 45x195 (170), this acts as a fender and give the bridge a sharp and stylish setting.
The deck is 34x145 groove pine. Slotting Nobody gives a very good grip to walk on and a neat appearance. Inge Ting nailed down, everything is screwed with stainless steel screw for maximum strength and durability.
In order to minimize tripping and injury risk the dock has no bar on top of the deck, it is completely smooth. It also makes it easier to put up boards to adjust the chains.
All wood is impregnated acc. to NTR A.
Concrete, reinforcement and fastening products meet all the requirements.
The dock can be supplied with water hose and housing for an electric cable, ready for connection of water and electricity.

Vågdämpare

Betongponton

Trä & betongbrygga